Log In | Checkout | 0 item(s)

Your Shopping Cart is empty!

Home

Specials Log In Create Account Checkout

Your Shopping Cart is empty!

Categories

Aquarium RO + DI Systems Drinking Water RO Systems Aeroponics Hydroponics RO System CounterTop Systems Whole House Systems Replacement Filters->Housing Canisters Faucets Water Spout TDS Meters & Flow Meters Pumps Valves Fittings Accessories Components Specialty Filters Bulk Purchase

Information

Frequently Asked Questions FAQ

-> System and Product Dimension

-> Booster Pump / Low Pressure:

-> Booster Pump Setup – Pressure Gauge and adjusting pressure:

-> Tubing Operating Pressure and Material:

-> Non Air-Gap Faucet:

-> Draining water ratio: 1:3:

-> RO System Knowledge Things You Should Know:

-> How to install float valve FV14 FV15:

-> UV BALLAST INFO:

-> Aquatec CDP6800 wire and tapes:

-> Water running continuously nonstop drain when tank is full:

-> Requires drain water! DO NOT block off the drain:

-> Tips on saving water:

-> Pressure Gauge rattle sound:

-> Faucet started dripping constantly:

-> Fluoride Removal:

-> Faucet Drill Hole Size:

-> When to replace filters:

-> Alkaline System and how it works:

-> Add Alkaline filter to an existing system:

-> TDS Calibration:

-> Third Party Product Warranty Warranty Claims:

-> Not using the drinking water feature on RD106:

-> Tank takes long time to fill, troubleshooting:

-> Not much or Little Water out of RO system:

-> Leaking Faucet / Dripping faucet:

-> K5 and RO585 difference:

-> Add water storage tank to RO unit:

-> AR122 and RD102 are not a drinking water system:

-> Why pumps are wet when they are new:

-> Permeate pump and waste water:

-> PH strips is not good:

-> Pressure Gauge is missing:

-> Clear Filter Housing Warning Advice:

-> Unable to open Filter Housing:

-> K5 Faucet Swap Substitute:

-> Booster pump to increase pressure:

-> Tank installation instruction:

-> Permeate or Booster Pump Noise:

-> When to replace filters:

-> Why install booster pump before 4th stage membrane:

-> Pressure switch does not shut off pump sometimes:

-> TDS reading ppm of the filtered water:

-> Is storage pressuer tank necessay for RO system:

-> O ring o-rings of Filter Casing Housing not available:

-> Flow meter display instruction:

-> Flow meter measurement accuracy:

-> Air Bubbles in the water:

-> Whole House System vs RO System:

-> Booster pump for misting application:

Installation of Auto Shutoff Valve:

-> DI Filter is leaking or unable to tighten:

-> Cracked Elbow Fitting:

-> What is Flow Restrictor in RO Systems?

-> ESO and TSO:

-> New Feed Water Adapter

-> Instruction for Refilling the 215 Inline DI filter

Support Manuals

Shipping,Tax,& Returns

Terms & Conditions

Product Showcase

Aquarium Photos

Installation of Auto Shutoff Valve:

The Auto Shutoff valve has 4 connections as follows:
-The side with the marking (IN) is connected to filter #3
-The side with the marking (OUT) is connected to the input of the membrane cap stage #4
-The side with no marking with screws, it’s called the screw side of the “in” is connected to the check valve
-The screw side of the out is connected to the tee fitting of stage#5 inline carbon filter

Home | Specials | Log In | Create Account | Checkout | Shopping Cart

Copyright © 2025 Filter Direct.